B 499192000929072015
THERMEX
JACOB JENSEN FJERNBETJENING
75
When using the remote control for the first time, the accompanying batteries must first be in-
serted:
•
Remove the battery cover on the bottom of the remote control
•
Place the battery cover on the remote control.
•
The remote control is now ready for use, and all icons will light up, except for the “torch”
icon.
COUPLING UP THE REMOTE CONTROL TO THE HOOD
As a radio frequency system is used between the remote control and the hood, the two units
must be coupled up. When you receive the hood, it has been coupled to the accompanying re-
mote control. The connection between the two units can however be lost, and must subse-
quently be coupled up again.
This is done in the following steps:
•
Switch off the mains power to the hood (it is not enough the light and extraction on the hood
are turned off). The power must be disconnected for at least 30 seconds, to ensure that the
electronics are reset.
•
Ensure that the remote control is ready for use and the batteries are correctly inserted. Check
that the remote control can be activated.
•
Reconnect the power to the hood. If the power has been connected for long enough, you will
hear a 'beep' from the hood.
•
Switch on the remote control, activate one of the functions and activate the slider panel. This
must be done within 8 seconds of the power being reconnected to the hood.
•
If coupling is done correctly, the remote control will start to control the hood's functions.
•
If the coupling fails, start the process again.
Insert the batteries,
taking care to position
them correctly.
EN
GL
IS
H
»
C
O
U
PL
IN
G U
P T
H
E R
EM
O
TE C
O
N
TRO
L T
O T
H
E H
O
O
D
Summary of Contents for JACOB JENSEN
Page 2: ......
