M 520191251230102017
THERMEX
SUPER SILENT UDTRÆK
37
ENGLISH
»
INS
TALL
ATION
INSTALLATION
There are various models of Super Silent Extractor available. It is designed for installing in a cabinet or on a wall by using the enclosed brackets. Super
Silent Extractor can be supplied with both an internal and external motor and can be used for extraction to the outside or recirculation.
Follow the instructions that match the model and type of installation you have chosen.
INSTALLATION IN A CABINET
The hood can be mounted underneath a cabinet. This is done by following the steps below:
Measure out to the motor box underneath the
cabinet.
Cut a hole in the hood’s motor box on the
underneath of the cabinet.
Mark out the positions of the four screw holes
on the underneath of the cabinet.
Pre-drill the four holes on the underneath the
cabinet.
Mount the hood in the cabinet using the four
screws supplied.
Push the plugs into the four screw holes in the
hood.
Install the exhaust outlet on the hood. Take
care to ensure the non-return valve can open
and close freely.
NOTE: It is important to let the air out of the ca-
binet if the hood is to be used for recirculation.
x4
1
2
x4
3
4
x4
5
x4
7
6
Summary of Contents for Super Silent Udtraek
Page 2: ......
