THERMEX
SUPER SILENT UDTRÆK
M 520191251230102017
38
ENGLISH
»
INS
TALL
ATION
WALL INSTALLATION
The hood can be installed on the wall on with the brackets supplied. This is done by following the steps below:
Mount the brackets onto the motor box of the
hood. This is done by using the four screws
supplied.
2
Mount the spacer on the hood to close the gap
between the hood and the wall.
NOTE: The spacer can be used in two ways de-
pending on the distance to the wall.
1
Measure out the position of the holes for the
installation of the hood.
Pre-drill the holes and install rawlplugs intended
for the material into which they are installed.
4
Mount the hood on the wall using the two
screws supplied.
5
Push the plugs into the four screw holes in the
hood.
Install the exhaust outlet on the hood. Take
care to ensure the non-return valve can open
and close freely.
NOTE: This only applies when venting into
open air.
7
x4
x2
x2
3
x2
x4
6
Summary of Contents for Super Silent Udtraek
Page 2: ......
