7
ENGLISH
INSTALLATION
INSTALLATION
UNPACKING THE PRODUCT
Solar collectors are supplied in packages containing 1, 2 or 5
panels
Pallet contents:
- collector
- document envelopes containing instruction manual,
bar code labels and data label.
2
2
1
b
Be careful not to lose the two flat gaskets (1) in the corner
(2) of each collector.
b
The instruction manual is an integral part of the solar con-
nector. Once located, read it thoroughly and keep it safe.
b
STORE IN A DRY PLACE AND DO NOT EXPOSE TO DIRECT
SUNLIGHT UNTIL THE TIME OF INSTALLATION!
The pack-
aging is not designed to protect the product against rain
or humidity. It can also degrade if exposed to direct sun-
light. Failure to comply with these precautions could lead
to irreparable damage to the product.
b
A protective film is applied on the collector glass, gener-
al and handling information is written on it. It must be re-
moved after the installation of the solar collector, only when
the operation of the system is required.
Installation
HANDLING
- Separate the solar collector from the wooden pallet by
removing the film wrapping
- Apply the data label (provided in the document enve-
lope) to the back of the solar collector
Once you have removed the outer packaging, proceed as fol-
lows to unpack and handle the solar collector:
- Tilt the solar collector slightly and grip it at the four
points shown (A) to lift it.
- Use a hoist or other suitable lifting equipment to hoist
the solar collector on to the roof.
Data label
A
A
A
A
Codice . . . . . . . .
Modello . . . . . . .
Matricola . . . . . .
Codice . . . . . . . . . . . . . . . . . . . . .
Tipo . . . . . . . . . . . . . . . . . . . . . . .
Dimensioni. . . . . . . . . . . . . . . . . .
Superficie lorda . . . . . . . . . . . . . .
Superficie di apertura . . . . . . . . .
Superficie assorbitore . . . . . . . . .
Peso a vuoto . . . . . . . . . . . . . . . .
Massima pressione di esercizio .
Contenuto liquido . . . . . . . . . . . .
Massima concentrazione glicole .
Liquido termovettore . . . . . . . . . .
COLLETTORE SOLARE (neutro)
FABBRICATO IN ITALIA da Riello S.p.A.
Temperatura di stagnazione . . . .
°C
TCOLL_NEUTRO2
b
Wear suitable personal protective equipment and use
suitable safety devices.
a
Do not dispose of packaging material into the environ-
ment, or leave it within the reach of children, since it can
become a potential hazard. Dispose of packaging mate-
rial in compliance with applicable legislation.
a
Do not lift the solar collector by its water fittings.