36
Installing the Fuel Pump and Fuel Lines
FOR UNDER CHASSIS FUEL TANKS
Installation Recommendations
•
All fuel lines should be routed in a protective housing with no kinks
and sharp bends.
•
Rubber grommets must be used when routing fuel lines through
holes in metal.
•
Secure all fuel lines with provided clamps.
•
Remove plastic cap from the fuel vent and point the outlet towards
the rear of the trailer.
Installing the Fuel Pump and Fuel Lines
1. Install the fuel pump and bracket as low as possible to provide rapid
pump priming.
2. Route the
fuel supply
line from the fuel filter located inside the unit,
down to the fuel pump and then to the fuel pickup tube on the fuel tank.
Install fuel line connectors (provided in installation kit), cut end of fuel
line at a 45 degree angle and insert into fuel pickup tube until it is
38.1 mm (1.50 in.) from the bottom of the tank and tighten securely.
3. Route the
fuel return
line from the fuel filter located inside the unit
down to the fuel tank return fitting. Attach fuel line connectors and
tighten securely.
4. Route the electrical harness from the unit to the fuel pump and attach to
the fuel pump connector.
The connector must be installed out of road
spray area.
NOTE: Add sufficient amount of fuel (1/4 tank) to allow the unit to run
for 8 to 12 hours during engine break-in and pre-delivery procedures.
DANGER: Leaking fuel lines could cause a fire resulting in
death or serious injury! All fuel line fittings must be tight and
leak free!
DANGER: Do not route fuel lines with battery cables or
electrical wires, as this could cause a fire!
Summary of Contents for HK-430 HO
