Operating Instructions
108
The first enabled Change Mode Menu selection will appear. To
choose that function, press the SELECT Soft Key. To Scroll
through the enabled features in the Change Mode Menu, press
the UP and DOWN Soft Keys (Figure 132).
Figure 132: Select, Up, Down Keys
Possible Mode selections are shown later in this section.
•
Only those modes that have been enabled will appear.
Only the Cycle Sentry Menu is enabled on factory units.
•
Not all modes may be available, depending on OptiSet
Plus usage and the settings of other programmable
features.
•
To return to the Standard Display press the EXIT Key.
•
The modes shown on the following pages may be
available.
Turn Cycle Sentry On or Off
Cycle Sentry Mode can be turned On or Off if Cycle Sentry
Mode is allowed by OptiSet Plus. If Cycle Sentry is turned off
the unit runs in Continuous Mode, unless Continuous Mode is
not allowed by OptiSet Plus. Either Cycle Sentry or
Continuous operation can be disabled via OptiSet Plus. From
the Main Menu > Change Mode menu choose Turn On/Off
Cycle Sentry Mode and press the SELECT Soft Key (Figure
133).
Figure 133: Select Key
If the unit is running in Cycle Sentry Mode, press the SELECT
Soft Key (Figure 134) to turn off Cycle Sentry Mode as shown
below.
ON
OFF
CHANGE MODE
DOWN
EXIT
SELECT
UP
TURN ON CYCLE SENTRY MODE
FAHRENHEIT
KEYPAD LOCKOUT
START SLEEP MODE
ON
OFF
CHANGE MODE
DOWN
EXIT
SELECT
UP
TURN ON CYCLE SENTRY MODE
FAHRENHEIT
KEYPAD LOCKOUT
START SLEEP MODE
