Alarm Codes
145
Clearing Alarm Codes
Most alarm codes can be cleared conventionally from the
Alarm Menu using the CLEAR Key. See the Operating
Instructions chapter for procedures.
The operator should contact a supervisor or a Thermo King
dealer about clearing alarms using the Guarded Access Menu.
Refer to the table on the following pages for alarm corrective
action.
NOTE: Document all alarm faults and report them to the
service technician.
There are three levels of corrective action that can be taken
when an alarm condition occurs.
OK To Run:
An alarm condition exists but does not affect
unit operation. Corrective action can occur at a later date.
Check As Specified:
An alarm condition exists that could
affect unit operation. Follow directions in the Corrective
Action column on the following chart.
Take Immediate Action:
An alarm condition exists that
will damage the unit or load. Take immediate action to correct
the problem.
NOTE: The corrective actions listed in the Operating
Instructions chapter and in the chart on the following pages
are suggestions only. Always consult your company for final
decisions.
NOTE: The chart on the following pages shows all possible
alarm codes for all possible applications. Not all codes will be
applicable to each individual unit.
