Operating Instructions
49
Figure 37: TemperatureWatch Display
If an alarm condition (other than a log alarm) is present, the
TemperatureWatch Display will not appear. If an alarm
condition occurs while the TemperatureWatch Display is
present the display will return to the Standard Display to
indicate that an alarm condition has occurred.
If the Defrost Key or Cycle Sentry Key is pressed, the display
will return to the TemperatureWatch Display immediately after
the defrost cycle is initiated or the operating mode is changed.
Changing The Setpoint
The Setpoint is changed from the Standard Display. If the
TemperatureWatch display is present, press any key to return to
the Standard Display.
IMPORTANT: If OptiSet Plus is in use there are several
possible options when changing the setpoint.
Numerical Setpoints
If OptiSet Plus is not in use or if only Numerical Setpoints are
enabled the left soft key will be labeled SETPOINT (Figure
38).
Figure 38: Setpoint
MENU
35
°F
35
TEMPERATURE
SETPOINT
.8
ON
OFF
ON
OFF
MENU
35
°F
35
SET
SENSORS
GAUGES
POINT
.8
