Installation Instruction
6
Installation and Operation Manual
ADA Undercounters - Laboratory Refrigerators & Freezers
5.3 Reversing The Door
Swing
•
This appliance can be opened from either the right side or the left. By
default, the door hinge is on the right side. If you prefer it on the left,
please follow below instructions. Holes on the opposite side have already
been prepared at the factory.
All of the parts that are removed must be kept for the reinstallation of the door.
1. Unscrew the lower hinge and take off the door.
2. Push the kick plate to the right in the new position.
3. Undo the upper hinge fastener and fix it to the opposite side of the
housing, where you have already removed and replaced the fastener with
the hole to the opposite side.
4. Put the door on the upper hinge fastener.
5. Fix the lower hinge in the new position.
6. Unscrew the handle and place it on the opposite side.
7. Some screws are covered with caps. Take off these caps before undoing
the screws.
8. Check the door gasket. It should not be creased and should seal well.
1. Upper Hinge fastener
2. Lower Hinge
3. Kick Plate
4. Door Handle
5. Door Hinge Fixture
6. Door Hinge Fixture Plug
