ES Series Lab Freezer
22
Disposal of your Freezer
When disposing your Freezer do not take it to regular municipal waste containers. Instead, take it to an electrical/
electronic waste recycling and re-use center. This Freezer contains insulation gases and refrigerant and must be
disposed of in the appropriate manner. Please contact the manufacturer or local authority for advice on how best to
dispose of this product.
A relevant label has been placed on the Freezers packaging (see below). The product has been manufactured of
recyclable materials. Ask your local environmental care authority for information concerning location of such facilities.
Troubleshooting
PROBLEM
REASON
SOLUTION
The equipment does
not work
A gap in the electric system circuit.
1. Make sure the plug inserted into socket
2. Make sure the socket is not faulty.
3. Make sure the power supply cord is not damaged.
The compressor hardly ever
activates.
1. Check to see if the ambient is below +10°C
The temperature inside
the equipment is not
low enough (the
compressor operates
continuously)
The door does not shut tight or is
opened too often.
1. Re-
arrange the products so they don’t hamper the door.
2. Shorten the time the door is open for.
The ambient temperature is above
that which has been outlined in the
product specification.
1.Check the equipment is operating at an ambient temperature that
meets the product specification.
Air circulation at the sides and back
of the equipment is hampered.
1. Move equipment further away from the wall and endure
adequate clearance on both sides.
The equipment is placed such that it
is subject to constant sunlight, or
another heat source e.g. Radiator.
1. Move the equipment to a different place away from heat sources
or direct sunlight.
Water collects at the
bottom of the Freezer.
The contents touch the back wall of
the cabinet.
1. Move the products so they are not in contact with the back wall.
The drain opening is clogged
refrigerator only.
1. Make the cleaning plug and unclog the condensate opening.
The equipment makes
too much noise.
The equipment is not level.
1. Place the equipment on an even surface or use adjustable feet.
The equipment is touching another
object.
1. Reposition the equipment so it is detached from any other
objects.
