3
ES Series Lab Freezer
General Recommendations
Intended Use and Special Warning
This equipment is tested in compliance with established regulations and then shipped ready for use. This
equipment is intended for general purpose cold storage and is not to be used in the presence of explosive gases
or mixtures and/or close to sources with high magnetic or electric fields.
WARNING:
These units are not medical
devices and have not been registered with a
medical device regulatory body (e.g.
MDD/MDR). These products have not been
evaluated for the storage of samples for
diagnostic use, nor for samples to be re-
introduced into the body. AEV and AEW
models are not intended for flammable
material storage. Only AXV & AXW models
are intended for flammable material storage.
If the equipment is used in a manner not
specified by the manufacturer, the protection
provided by the equipment may be impaired
.
WARNING:
Do not damage the
refrigeration circuit
WARNING:
Do not use electrical
equipment inside the food storage they are
of the type recommended by the
manufacturer.
WARNING:
Keep ventilation openings, in
the equipment enclosure or in the built-in
structure, clear of obstruction.
WARNING:
Do not use mechanical
devices or other means to accelerate the
defrosting process, other than those
recommended by the manufacturer
Energy Saving Tips
This equipment is cooled by energy efficient R600a refrigerant.
To keep running costs as low as possible always:
•
Position the equipment away from heat sources.
•
Make sure the air can circulate freely around the equipment, don’t block ventilation grid
•
Ensure that products being stored are below room
temperature upon entry.
•
Make sure the door is opened as little as possible while in
use and closed as quickly as possible to prevent
unnecessary temperature fluctuations.
Important Information
The freezer contains environment-friendly, non-ozone depleting refrigerant R600a. As R600a is a flammable gas, it
is important to avoid damage to the refrigeration circuit during transport and installation. If the refrigeration circuit is
damaged, avoid using a naked flame in the vicinity of the freezer and connecting power to the freezer. Also make
sure there is good ventilation in the room. If you are in doubt, please
contact your supplier.
