2
Rev 1.0, Cat. no. N11468
To create a new protocol:
Step
Action
1 Press
NEW
and the default protocol will appear. The temperature for each step is represented above the line
and the time (min:sec) below the line.
2
Use the cursor keys to navigate to each step/value.
3
Modify the value with the keypad (for example, for 60.5, press 6, 0, 5). To enter an infinite hold, press [±∞].
4
To add a temperature step, press
ADD
and then
TEMP
. The steps are added to the right of the current step.
5
To add a loop:
- Highlight the last step in the loop.
- Press
ADD
and then
GOTO
.
- Use the cursor keys to move the arrow to the desired first temperature step in the loop.
- Press
YES
to accept or
NO
to cancel the GOTO step.
- Edit the number in the center of the arrow to adjust the number of repeated cycles.
6
To delete a highlighted step, press
DELETE
.
7
To save a protocol:
- Press
SAVE
and write the desired file name.
- Press
SAVE
again.
- Highlight the desired folder and press
SELECT
or press
NEW
to create a new folder.
- Press
YES
to save the protocol.
To edit an existing protocol:
Step
Action
1 From
the
Main
menu, press
RUN
.
2
Use the cursor keys to navigate to the desired folder and press
OPEN
.
3
Select the desired protocol and press
OPEN
.
4 Press
EDIT
to make changes as instructed in Steps 1–7 (above).
To run an existing protocol:
Step
Action
1 From
the
Main
menu, press
RUN
.
2
Use the cursor keys to navigate to the
desired folder and press
OPEN
.
3
Select the desired protocol and press
OPEN
.
4 Press
START
.
5
Follow on-screen instructions.
Manufactured by:
Distributed by:
Thermo Fisher Scientific Oy
P.O. Box 100, FI-01621 Vantaa, Finland
Tel. +358-9-329 100, Fax +358-9-3291 0415
www.thermoscientific.com
Display
Alphanumeric keypad
Five function keys
Cursor keys
Enter key
Block shift
key for
dual blocks
