Continuµm User Guide 185
4. Install OMNIC Atlµs.
Notice
For many video capture (and other add-on cards) the drivers
and software must be installed before the hardware.
Read and follow the installation instructions that accompany the
card(s). Incorrectly installed software, hardware, and drivers can
render your computer inoperable.
In many cases, the installation instructions are included on a
compact disc that was shipped with the card. Adobe® Acrobat®
Reader software frequently is required to view and print the
documentation. If the instructions are provided in electronic form,
we recommend that you print a copy. You will be powering off and
restarting the computer during the remainder of this procedure.
Having a paper copy of all the manuals will simplify the installation.
Pay attention to any Display or other Control Panel setting
requirements.
Service calls required to correct problems caused by incorrect
installation and display settings are not covered under
warranty.
5. Install the video capture software and hardware.
6. Shutdown and power off the computer.
7. Power on the computer and install the serial port driver
software that accompanied your add-on serial port cards.
8. Shutdown and power off the computer and then install the
add-on serial ports.
Summary of Contents for Nicolet Continuum
