General Purpose Refrigerator and Freezers
Using the Display | 11
Using the Display
The refrigerator is equipped with a latest generation
Electronic Controller, with an alphanumeric LCD display
that shows the temperature and operating status with
increments of 0.1°C. The controller ensures maximum
safety in case of alarms and fault conditions, promptly
signaling critical conditions and recording every event to
help the service engineer to speed up analysis and thus
fix problems.
Control Unit
Figure 10. User Interface
Controller Operation
Switching On
To switch on the equipment for the first time follow these
below instructions:
Table 2. Keyboard function
UI
Command
To confirm the selection
Value increase button,
menu scrolling and
DOCTOR VIEW function
To enter the main menu
and Esc function from all
menus
Value decrease button,
menu scrolling Glass
door LIGHT on/off
Alphanumeric back-lit
LCD display
Table 3. Steps to Switch On
Action
Display
1
Connect the
plug to the
electric socket.
2
The display
shows
“STAND-BY”
which indicates
the presence of
mains power.
3
Press any
button for
approximately
2 seconds to
switch on the
refrigerator.
4
The LCD
display can be
configured in
four different
display modes
by pressing the
button OK.
Pause +4.5°C
S+4.0°C
+4.5°C
12:44 01/01/2020
56% Rh
+4.5°C
Mode 1
Mode 3
Mode 4
Mode 2
