General Purpose Refrigerators and Freezers
Installation | 7
Installation
Selecting a Location
Choose a location for the TSV07CPSA (Refrigerator and
Freezer) that provides a clearance of 12 in. at the top, 4 in. at
the rear and 4 in. on each side.
Choose a location for the TSV05RPSA (Under-counter
Refrigerator)/ TSV05CPSA (Under-counter Refrigerator/
Freezer) that provides a clearance of 4 inches on all sides.
Appropriate electrical power must be available. Locate the
refrigerator/freezer within eight feet of the power outlet so that
no extension cord is required. Attach the refrigerator/freezer
to the facility’s electrical supply as directed by the National
Electrical Code.
Leveling the Unit
This refrigerator/freezer must be level in order to provide
adequate condensate drainage as well as proper door
alignment and operation. The refrigerator/freezer should be in
its final operating location and set so that it is firmly positioned
on the floor.
Electrical Connection
Determine the total amount of current presently being used by
other apparatus connected to the circuit that will be used by
this refrigerator. It is critical that this added current demand
and other equipment on this circuit not exceed the rating of
the fuse or circuit breaker in use.
The frequency and nominal voltage requirements for the unit
are specified on the data plate. Supply this unit with an
electrical source that meets these requirements only. Low line
voltage is often the cause of service complaints. With the unit
running, check that the line voltage is within ±10% of that
specified on the data plate.
General Purpose units must be connected to a grounded
outlet matching the nameplate and / or the information
furnished in this manual. If you are not sure about the outlet,
you should contact a qualified electrician for assistance.
The Unit should always be connected to a dedicated power
source.
Reversing the Front Door
(TSV05RPSA)
1. Remove bolts and plugs using a screwdriver.
2. Unscrew the bolts connecting the upper hinges to the
upper platform. Remove the upper platform by first
pulling it forward and then lifting it upwards.
3. Remove the door by unscrewing the bolts in the upper
hinges.
4. Remove the buffer by unscrewing the bolts on both of its
sides.
5. Break off the part behind the buffer through which the
lower hinges pass using a knife or your hands.
6. Remove the lower hinge and mount it on the other side
tightening its bolts.
7. Remove the hole plugs of the door handle with a knife.
8. Fit the hole plugs of the door handle to the other side.
9. Fit the buffer to its place.
10. Mount the door to its place.
11. Fit the upper hinges into their places - do not tighten the
bolts, but leave them loose.
12. Adjust the vertical and parallel position of the door to the
line of sight, then tighten the bolts of the upper hinges.
13. Fit the upper platform into its place.
14. Fit the bolts connecting the upper hinges and the upper
platform but, do not tighten them.
15. Adjust the upper platform until it is level, then tighten the
bolts in operations.
16. Fit the plugs of the upper platform.
CAUTION:
Be sure the voltage supplied to the
refrigerator/freezer is equal to that specified on
the data plate.
WARNING:
For personal safety, this unit must
be properly grounded before use.
WARNING:
DO NOT REMOVE, under any
circumstance, the grounding prongs from the
3-prong power cord supplied with all units.
WARNING:
DO NOT USE electrical extension
cords, it may result in voltage loss and possible
hazardous operation.
