MULTIFUNCTIONAL UNITS RLC – Installation and maintenance manual
MUMRLCHEAT_REV01_1012_UK
Pag. 5 di 31
2.3
Unit identification
2.3.1
Label
The unit is identified by the following label.
It contains the kind of the unit (serial and size), the serial number, the production year, the electric
data, the main technical data, logo anche manufacturer address.
In case of loss request for a duplicate to the after sale service.
Tampering and/or removing the label does not allow the identification of the product, and makes
difficult any installation and maintenance operation.
2.3.2
Serial number
The serial number identifies the unit unambigously, it permit to identify the specific characteristic of
the unit and the installed components. Without this code it is not possible identifies the specific
spare parts of the unit. In case of request for repair it is necessary the model and the serial
number.
2.4
Factory inspection
Thermocold units are inspected into the factory, in appropriate areas, in accordance with internal
procedures. Each performance test carried out on the unit is possible only if the same conditions
are reproduced and maintained (charge consistency, constant temperature and evaporation - condensation and recovery capacity, quality
and tolerance of the measuring instruments etc.) in the test rooms.
The inspection conditions are those indicated by the customer in the ordering phase: if not otherwise specified, reference should be made
to the nominal performance indicated in the technical bulletin in force at the date of the Confirmation of the Order.
