Installing the Nicolet iN5 Microscope
This document contains confidential or proprietary informat ion of Thermo Fisher Sc ientific. Ne ither this document nor
the information therein is to be reproduced, distributed, used or disclosed, either in whole o r in part, e xcept as
specifically authorized by Thermo Fisher Scientific.
1/4/2018
Page 11 of 84
e. Slide the interface toward the iS10 until the end of the channel is fully
engaged with the locator pin.
f. Using a needle nose plier, remove the purge plugs from the iS10 at the
following locations, see below and on the following page.
Set purge
plugs with the customer parts.
Remove plug from sample compartment
Remove plugs from right edge of iS10 baseplate
