Installing the Nicolet iN5 Microscope
This document contains confidential or proprietary informat ion of Thermo Fisher Sc ientific. Ne ither this document nor
the information therein is to be reproduced, distributed, used or disclosed, either in whole o r in part, e xcept as
specifically authorized by Thermo Fisher Scientific.
1/4/2018
Page 41 of 84
c.
Using two 5/64 inch balldrivers, adjust the condenser X-Y alignment screws
to center the target image and then continue with step 27.
Adjust condenser X-Y alignment
25. If you cannot find the target image, slowly raise or lower the condenser until
you see a dark spot as depicted below. This is the back of the secondary
mirror.
