Installing the iN10/iN10MX
This document contains confidential or proprietary information of Thermo Fisher Scientific. Neither this
document nor the information therein is to be reproduced, distributed, used or disclosed, either in whole or
in part, except as specifically authorized by Thermo Fisher Scientific.
8/3/2020
Page 14 of 61
24.8.
Attach the interface plate to the iN10.
Tip the iZ10 up from the
right side so the interface plate tips down and align the channel with
the pin under the left side of the iN10.
Carefully slide the plate under the iN10 until the pin is at the end of
travel.
24.9.
Attach the interface plate to the iN10.
Using the 3 remaining
screws from the interface kit, attach the plate to the iN10 using a
3/16” L-wrench. Use pliers to tighten the screw on the right side of
the firewall.
Pin
