OdaLog
®
Gas Logger User Manual
P/N: 10-1000
Revision: F, Issued: October 2019
Page: 13
6.9 BT (Bluetooth Data Communication Mode)
6.9.1 Enter “BT” mode (Bluetooth Data Communication Mode)
From ON Mode:
From the ‘INST’ screen, press & hold button down until “BT” is displayed then release
button (BT will appear on screen after ‘irDA’, see diagram in Section 6.1).
From OFF Mode:
From the ‘OFF’ screen, press & hold button down until “BT” is displayed then release
button (BT will appear on screen after the “ON” countdown and the test screen/s and
“irDA”, see diagram in Section 6.11).
Note 1:
This can only be done when logging is stopped, unless Auto Log Start is active. (See Section 6.7)
6.9.2 Exit “BT” mode (Bluetooth Data Communication Mode)
Pressing the button when in “BT” mode or waiting 75 seconds for unit to “time out” will cause the instrument to
exit communication mode.
6.9.3 Pairing Instrument with PC
The Odalog instrument must be paired with the PC before the communication can be established. Pairing
procedures:
Enter “BTPAIR” mode on the instrument LCD, following the same procedures given in 6.9.1
Pairing with Windows 7
o
Enter Devices and Printers
o
Click Added a Device
Pairing with Windows 10
o
Enter Devices and Printers
o
Select Bluetooth
o
Click Added a Device
o
Click Pair
6.9.4 Communications Set-up
If using a
USB
-based Bluetooth adapter, ensure the drivers are installed
BEFORE
connecting the
device
Connect Bluetooth device to your PC and install the
OdaStat-G™
software package.
Open the
OdaStat-G™
software package on your PC, and ensure communication setting are configured
correctly to communicate with your OdaLog
®
instrument (refer to
OdaStat-G
™ software package
Help
)
Place OdaLog
®
into
Bluetooth
Mode
Position the Odalog instrument within 10 meters from the PC
Disconnect instrument when finished and remove the instrument from the device list on the PC
