1
a.
Mounting Method 1: Secure wall mount
bracket to mounting surface using pipe band
provided with kits.
2
These steps replace Steps 1-6 in the
installation instructions provided with
Terminator kits.
1b.
Mounting Method 2: Secure wall mount
bracket to mounting surface using #10 x 1”
screws, #10 flat washers, and #10 nuts.
2.
Take apart expeditor assembly and discard
support base. Make sure not to discard
grommet.
3.
Put together expeditor assembly using wall
mount support base. Place grommet in
support base. Snap threaded grommet
compressor into support base. Screw support
cap onto support base.
4.
Mount expediter to bracket using M5 x 8 mm
screws and M5 lock washers.
5.
Locate bus connection (HPT and FP only)
as shown. Cut end of cable at angle to aid in
piercing grommet. Leave additional cable for
expansion as needed.
6.
Insert cable into expeditor. Make sure bus
connection (HPT and FP only) remains
outside of expediter.
7.
Cut off end of cable.
Terminator
TM
ZP-WMK
INSTALLATION PROCEDURES
