Page 8
3. How to Operate the
NL-22 press
3.1
Starting with the NL-22 press
3.1.1
Plug into your supply
outlet and switch supply on.
N.B.
Please ensure the mains plug is easily accessible to the
operator so that in the event of a fault the machine can be
unplugged.
3.1.2
Turn on the NL-22 press;
the on/off switch is to the right of the
controller. Set the machine controls as necessary. See instructions
for adjusting the pressure,
2.4
, and the operation of the time
temperature unit,
5.2
. When the set temperature is steady in the
display the machine is ready to use
3.2
Working with Heat Transfer Materials
This section
is divided into Transfer Marking/Transfer Printing and Heat
Bonding and Fusing.
First ascertain from the supplier
of the material that it is suitable to be
used, and obtain the correct heat and time dwell setting for the material and
transfer. Approximate settings may be as follows:-
3.2.1
Transfer Marking
NOTE: Transfer marking
is usually for the marking of materials for
identification purposes and should not be confused with the
transfer printing, as mentioned in the next section.
3.2.2
Transfer Printing
NOTE:
Always ascertain
from the supplier of material and transfer paper,
that the material to be used is suitable for, and has been prepared
for transfer printing.
200
o
C (392
o
F) - Heat setting
3 to 5 seconds - Time dwell setting
190
o
- 200
o
C (374-392
o
F) - Heat setting
20 to 30 seconds - Time dwell setting
Summary of Contents for Almere NL-22
