7
Thermorail Heated Towel Rails should be installed and tested by a qualified
electrician and in accordance with current local regulations. We recommend that
the rail is installed onto a flat uniform wall at least 600mm from the floor and
with a 300mm clearance from permanent fixtures. Where possible the Thermorail
Heated Towel Rail should be screwed into studs or if fixing to hollow walls suitable
anchors should be used to ensure rail in secure.
Please read and understand this installation guide in full before commencing
installation. If you have any queries in regard to installation, please call
1300 368 631.
•
Observe and adhere to electrical guidelines and IP ratings when placing your
Thermorail in wet areas
•
Ensure any timers or switches used are installed in correct zones according
to the IP rating of the timer/switch
•
Ensure that your Thermorail is protected by a suitably rated RCD circuit
•
Do not use the towel rail to hold towels or other articles that have been in
contact with oil, petroleum-based products or dry cleaning fluids
•
This appliance is intended to warm and dry towels and therefore is hot to
touch. When near young children or infirm persons, close supervision is
necessary.
•
Do not immerse your Thermorail in any liquid
The finish of your Thermorail Heated Towel Rail is protected by a lacquer. Clean
with a soft cloth and mild detergent. Do not use any harsh abrasives or thinners
on the Heated Towel Rail as this will damage the finish. Do not use and mashing
tape or solvents on the rail. The finish is a soft decorative finish and should be
handled as such and preferably installed after other trades such as paint,
plasterboard and tiling. Wipe over with a soft cloth and handle carefully.
Safety & Care Information
mation
