THERMOROSSI ECOTHERM 5000, Installation, Use And Maintenance Manual

pg. 3

THERMOROSSI S.p.A.
Via Grumolo. 4
36011  ARSIERO
tel.

0445.741310

fax

0445.741657

"CE" DECLARATION OF CONFORMITY

In accordance with the following directives:

European Directive

73/23/EEC and its amending directive

93/68/EEC

89/336/EEC and its amending directives

93/68/EEC
92/31/EEC
93/97/EEC

Thermorossi S.p.A., Via Grumolo 4 - ARSIERO (VI), declares that the heaters of the ECOTHERM series have been designed and manufactured
in compliance with the safety requirements of the standards for EC marking.
This declaration refers to the entire range of the specified series.
Ecotherm 5000 complies with EN 14785: 2006.

ARSIERO, 3 May 2010

THERMOROSSI S.p.A.

1

1

1

1

1

INTRODUCTION

INTRODUCTION

INTRODUCTION

INTRODUCTION

INTRODUCTION

1 . 1

1 . 1

1 . 1

1 . 1

1 . 1

GENERAL GUIDELINES

GENERAL GUIDELINES

GENERAL GUIDELINES

GENERAL GUIDELINES

GENERAL GUIDELINES

This installation, use and maintenance guide is an integral and essential part of the product and must be kept by the user. Before commencing with
the installation, use and maintenance of the product, carefully read all the instructions contained in this booklet. At the time of installation of the
appliance all local regulations, including those that refer to national and European regulations, must be observed. The Manufacturer recommends
carrying out all the maintenance operations described in this manual.
This appliance must only be used as intended by the manufacturer. Any other use is considered incorrect and therefore hazardous; consequently,
the user shall be totally liable for the product if used improperly. Installation, maintenance and repairs must be carried out by personnel with
professional qualifications and in compliance with current regulatory standards and in accordance with the instructions of the manufacturer of
the appliance. Use only original spare parts.
Incorrect installation or poor maintenance could injure or damage people, animals or things; in this case the manufacturer shall be relieved of all
responsibility. Before commencing any cleaning or maintenance operation ensure that the appliance has been disconnected from the mains
power supply by means of the main system switch or some other disconnecting device installed upstream from the appliance. The product must
be installed in locations suitable for fire-fighting and furnished with all the services (power and outlets) which the appliance requires for a correct
and safe operation. Any repairs or actions carried out on any systems, components or internal parts of the appliance, or on any of the
accessories supplied with it, that are not specifically authorised by Thermorossi s.p.a, will automatically void the warranty and the manufacturer's
responsibility, pursuant to D.P.R. 224 of 24/05/1988, art. 6/b.Use only original Thermorossi spare parts. If the appliance is sold or transferred to
another user ensure that the guide is handed over with it.

Thermorossi S.p.A. maintains the author’s rights on these service instructions.

The information in this booklet may not be reproduced or given to third parties or used for competitive purposes without the appropriate

authorization.

1.2 SAFETY GUIDELINES

1.2 SAFETY GUIDELINES

1.2 SAFETY GUIDELINES

1.2 SAFETY GUIDELINES

1.2 SAFETY GUIDELINES

PERSONAL INJURY

This safety symbol identifies important messages throughout the manual. Read the information marked by this symbol
carefully as non-observance of this message can cause serious injury to persons using the heater.

DAMAGE TO PROPERTY

This safety symbol identifies messages or instructions that are fundamental for the heater and system to function well. To
avoid serious damage to the heater adhere strictly to these instructions.

INFORMATION

This symbol indicates important instructions for good functioning of the heater. If this information is not correctly observed, the
performance of the heater and/or system will not be satisfactory.