pg. 8
5
5
5
5
5
DESCRIPTIONS OF CONTROLS
5 . 1
5 . 1
5 . 1
5 . 1
5 . 1
DESCRIPTION OF CONTR
DESCRIPTION OF CONTR
DESCRIPTION OF CONTR
DESCRIPTION OF CONTR
DESCRIPTION OF CONTROL P
OL P
OL P
OL P
OL PANEL
ANEL
ANEL
ANEL
ANEL AND HEA
AND HEA
AND HEA
AND HEA
AND HEATER REAR P
TER REAR P
TER REAR P
TER REAR P
TER REAR PANEL
ANEL
ANEL
ANEL
ANEL
5.1.1 DESCRIPTION OF THE CONTROL PANEL
There are two main control pushbuttons marked with the ventilation symbol (2) and the symbol of the flame (1).The flame pushbutton (1) sets
the power of the heater with 5 levels available which are activated as the 5 leds light up in sequence (10). The off cycle is activated when
all power leds are turned off. Key (2) controls the ventilation of the heater. It is activated when the heater body reaches a temperature over
42 °C. The fan can be set to any of speed levels (9): when the heater is on the ventilation cannot be switched off .
5.1.2 BACK PANEL OF THE HEATER
A description of the functions of the buttons and LEDs on the back panel of the
heater:
(11) Main switch 0-1
(12) Heater electrical power outlet 220-240V 50 Hz.
(13) Overtemperature thermostat button cap.
In the event of overtemperature this safety thermostat stops the loading of
pellets. When it is activated LED 15 comes on. To restart the heater you
need to wait until it cools down, then verify the cause for the overheating,
remove the cause, unscrew the protective cap and press the button (13) .
(14) Feed motor test indicator light. When the pellet screw feeder is set in
motion the light must come on.
(15) Reset thermostat tripped indicator light. This LED comes on when
the reset thermostat is activated.
(16) Power outlet for additional chronothermostat connection.
(additional chronothermostat not supplied )
(17) Power outlet for additional room temperature thermostat
connection. (additional room temperature thermostat not supplied)
All controls and indicators are presented here below :
(1) Insert on/off and flame adjustment button . When you press this button the appliance (10) switches to Start / ON / OFF.
Up to 5 leds (10) are activated when pressed repeatedly.
(2) Ventilation setting button . Press this button to set the desired level of ventilation: up to a maximum of 6 speeds are available,
indicated by the lighting of the corresponding leds (9).
(3) (4) Auxiliary setting keys.
Keys (3) and (4) are operating keys necessary when on-off cycles are programmed, for operative levels, clock setting, etc..
5) Programming Enable / Disable keys.
(6) “MENU” selection button To access the main menu press the button marked with 6. Press button 6 repeatedly to scroll the
adjustment, setting and programming windows.
(7) Display
(8) Infrared sensor for remote control
(9) Ventilation level leds .
(10) Combustion level leds
1
2
3
4
5
6
7
8
9
10
11
13
14
15
16
17
12
Key
Room temperature thermostat
Chronothermostat - modem
Motor. LED
Reset LED
Reset
LEGENDA
Termostato ambiente
Cronotermostato - modem
Spia motor.
Spia riarmo
Riarmo
Summary of Contents for ECOTHERM 5000
Page 16: ...pg 16 ...
Page 17: ...pg 17 ...