Page 17
Installation, use and maintenance guide
Pellet Air 11 Stove body
5.2 DESCRIPTION OF THE POWER PANEL
The components of the power panel are described below:
1) Electrical power outlet 220V-240V 50Hz
2) Main switch 0/I.
3) Test light for pellet feed motor.
The light comes on simultaneously with the activation of the pellet
feed motor.
4) Cap for reset thermostat button.
If the reset thermostat overheats stop the pellet feeder. The appliance
must cool down before you can restart the appliance. After verifying
and eliminating the causes of the event, undo the protective cap and
press the button.
5) Safety fuse.
5.3 DATE: SETTING THE DATE AND TIME
The appliance must be energised and the I/0 switch in position "1".
The current date and time can be set using the DATE function.
To set the current time and date proceed as follows:
1) Press the
Menu Button
once to view the
following screen:
After a few seconds the following screen will appear on the display:
2) Now press the
Scroll Buttons
to change the day of the week; each dot corresponds to one day of the week (e.g. 1 corresponds
to Monday, 2 correspond to Tuesday, etc...). To confirm the selection of the day of the week press the
Flame Button
.
Once confirmed, the selector shifts to the flashing hour section:
3) Press the
Scroll Buttons
to change the hour. Once you have set the hour confirm the value by pressing the
Flame Button.
Once confirmed, the selector shifts to the flashing minutes section. Press the
Scroll Buttons
to set the minutes. Press the
Flame button
to confirm.
Once confirmed, the date and time setting screen closes automatically and the initial screen returns to the display.
If you confirm the wrong value simply press the
Menu Button
to exit the box, the initial screen will appear, and repeat the
procedure described above.
5.4 CHRONO: ON/OFF PROGRAMMING
The CRONO function allows you to set the weekly program by setting up to 3 on-off cycles at different times for every day from
Monday through to Sunday.
To set a program follow the procedure described below:
1) Press the
Menu Button
twice
quickly to view the following screen:
Legenda:
Key:
RIARMO
RESET
SPIA MOTORIDUTTORE
RATIO MOTOR
INDICATOR
3
4
2
1
5