INSTALLATION, USE AND MAINTENANCE GUIDE
POPSTAR 6
– POPSTAR 10
Page
15
ENG
4.7 CONNECTING THE APPLIANCE TO THE FLUE OUTLET
Connection of the appliance to the flue outlet must be carried out in strict compliance with the instructions contained in this
use and maintenance guide.
TOP SMOKE OUTLET
The appliance is designed with the smoke outlet at the top. Remove the cover (G) and
insert the exhaust pipe with its sealing gasket. Remove the pre-cut section with a hammer
or hacksaw then return the cover (G) to its original position.
This operation must be exclusively performed by qualified professional staff, as
set forth by Decree no. 37 of 22nd January 2008 and applicable laws on the
subject. Before performing said task, make sure the power supply cable is
disconnected from the electrical power socket.
REAR SMOKE OUTLET
If you choose to use the smoke outlet at the rear then loosen the two screws (E) and
remove the side panel (F) by lifting it upwards. Unscrew the knobs (A) and remove the
bracket (B). Undo the screws on the collar (C) and the flange (D) and remove both
elements. Next interchange the positions of the collar (C) and the flange (D), secure them
and ensure that the seals are perfectly tight. Remove the cover with pre-drilled hole from
the bracket (B) and return the bracket (B) and the side panel (F) to their original positions.
anco (F) allentando le due viti (E).
This operation must be exclusively performed by qualified professional staff, as
set forth by Decree no. 37 of 22nd January 2008 and applicable laws on the
subject. Before performing said task, make sure the power supply cable is
disconnected from the electrical power socket.
Emissione:21/07/2020
Revisione:
H
G
Emissione: 22/07/2020
Revisione:
F
E
A
C
D
B
