Page 10
lation, use and maintenance guide
SIL
IC
O
N
E A
LT
A
TE
M
PE
R
AT
U
R
A
A
A
C
Figura 1
To glue the panes to the front panel, firstly apply silicone to the surface of the panel as illustrated in Figure 1. The silicone must be
suitable for high temperatures (>200° C). Attention: as highlighted in Detail C, do not apply silicone to the areas where the corners
of the glass cross over. If applied here the silicone could leak out and ruin the look of the product.
Position each glass pane by placing it in an inclined position and using the locators A indicated in Figure 1. When the edges of the
glass abut the locators A, delicately place the entire surface of the pane with the applied silicone and exert uniform pressure with
your hands over the whole surface, while making sure that the pane remains aligned in position. Repeat this procedure for all the
glass panes.
After checking that the panes are aligned with each other and with the front panel secure them in position by applying strips of
paper tape along the edges.
Wait at least 24h for the silicone to cure before handling the front panel. If the room temperature drops below 18°, wait 48 hours for
the silicone to cure completely.
4.4 CONNECTING THE APPLIANCE TO THE FLUE OUTLET
Connection of the appliance to the flue outlet must be carried out in
strict compliance with the instructions contained in this booklet (see
Chapter 9).
The appliance is fitted with the possibility for venting on three sides: top
left, side left and rear left (Figure 3).
Side or rear venting requires the use of a 90° elbow which is not supplied
with the appliance.
Once you have decided on the venting option that you wish to use, remove
the relevant precut shape. For this operation it is recommended to use a
blade for iron to prevent damaging the metal cover.
For instructions on how to install the smoke outlet in the wall, refer to the
technical drawings indicated in the “technical characteristics” in paragraph
2.
4.5 REMOUNTING THE FRONT PANEL
Once the appliance has been installed, the next step is to remount the front panel. Re-attach the front panel G to the body of the
appliance and lightly screw in the screws E (do not tighten). After checking that the front panel is aligned with the door (see the
alignment line in the drawing below) tighten the screws E. Complete the assembly of the heater.
A
L
L
IN
E
A
M
E
N
T
O
E
G
G
E
E
ALLINEAMENTO = ALIGNEMENT
SUPERIORE
LATERALE
POSTERIORE
Figura 3
TOP
SIDE
REAR
