Page 19
Installation, use and maintenance guide
If there are several appliances installed in rooms closely to each other it may be necessary to set different transmission codes as
this type of interference deactivates operation of the optional Thermocomfort radio control. To change the transmission codes
proceed as follows:
-Disable the Thermocomfort function. To disable it, in the START, WORK, OFF phases, repeatedly press button (6) on the
appliance's control panel until the word "THERMOCOMFORT" appears on the display (7) followed by the words Thermocomfort
On". To deactivate the Thermocomfort function simply press the button (3) : "Thermocomfort Off". To return to the original operating
function simply press the button (6) again.
-Switch off the Thermocomfort radio control by pressing the button (11R) on the device.
-To change the transmission codes, open the cover (13R) and act as indicated in the figure below.
-Next switch on the radio control by pressing the button (11R).
-Activate the Thermocomfort function. To enable it, in the START, WORK, OFF phases, repeatedly press button (6) on the
appliance's control panel until the word "THERMOCOMFORT" appears on the display (7) followed by the words Thermocomfort
Off". To activate the Thermocomfort function simply press the button (3): "Thermocomfort On". To return to the original operating
function simply press the button (6) again. The radio control may still not function even after having changed the transmission
codes. If this occurs change the codes once again using the procedure described above.
LEGENDA
KEY
Selettore codici per radiocomando palmare gestito via onde radio
Code selector for handheld radio control controlled by radio waves
6.4.3 CARE AND MAINTENANCE OF THE RADIO CONTROL
The radio control has been designed and produced to the strictest standards and must be handled with great care. If you observe
the guidelines set out below, the radio control will provide a long trouble-free performance:
• Protect the radio control against humidity! Precipitation, humidity and liquids corrode the electronic circuits. If the radio control is
wet, disconnect it immediately from a power source, remove the battery, open it and allow it to dry at room temperature.
• Do not use or store the radio control in dusty or dirty environments. The dust/dirt could damage the movable parts of the radio
control.
• Do not store the radio control in very hot environments. High temperatures could shorten the life of the electronic devices, damage
the batteries and deform or even melt plastic parts. Do not store the radio control in cold environments. When it heats up (when it
returns to normal operating temperature), humidity could form inside it and damage the electronic circuits.
• Do not drop the radio control, do not hit or bump it and do not shake it. Actions such as these could damage the internal circuits of
the device.
• Do not use corrosive chemical substances, caustic solutions or detergents to clean the radio control.
All the above guidelines apply to the radio control, the battery, the battery charger, and all the accessories. The parts
subject to wear (such as batteries, keypads, lodging compartments, small compartment parts) are guaranteed for 6
months from the purchase date. The guarantee does not apply if the defect is caused by non-conforming use and/or
if the instructions and guidelines described above are not observed to the letter. Devices or parts returned for
replacement become the property of Thermorossi S.p.A. The presence of any irregular black-blue lines on the
display, also present when de-energised and/or battery flat or missing, indicate that the glass screen of the display is
damaged following a fall or impact: in this case the breakage is not covered by the guarantee.
SELETTORE CODICI PER RADIOCOMANDO
PALMARE GESTITO VIA ONDE RADIO
ON
1
2
3
4
3
1
ON
2
4
THERMOCOMFORT
3
5
4
7
6
Thermocomfort
On
11 R
12 R
13 R
