Page 27
Installation, use and maintenance guide
8.4 CHARGING THE BATTERY OF THE THERMOCOMFORT HANDHELD
RADIO CONTROL (optional)
As soon as the battery symbol on the display begins to blink, as shown in the drawing,
the battery needs to be charged. While it is being charged and consequently while it is
connected to the electrical power mains the battery symbol blinks continuously even
when the batteries of the radio control are completely charged. This operation is
necessary as otherwise the communication between the appliance and the radio
control could be cut off. The batteries of the handheld radio control require regular
recharging in relation to the amount of use made of it The duration of the battery
charge is variable and depends on how often the remote control is used. The batteries
must be recharged using the supplied battery charger:
INPUT 100V-240V 50/60 Hz 0,3/A OUTPUT 5,5V 750 ma
The battery charger must be connected to a 220-240V 50Hz power mains. To obtain a total recharge of the batteries they must be
charged for at least 5 days: lower charge times could reduce the duration and life of the batteries. It is completely normal during the
battery recharge process for symbols and/or lines to appear haphazardly on the display. The optimal battery autonomy is achieved
after several battery charge / discharge cycles. If the radio control is not used for more than one week it is mandatory to switch it off
completely in order to preserve the life of the batteries. Turn the switch located in the battery compartment to 1, that is, OFF.
The batteries are guaranteed for 6 months.
Caution: Use only the battery charger provided by Thermorossi. The use of any other type of battery charger will invalidate
the product warranty. Flat batteries must be removed and safely disposed of. Use rechargeable AAA 1.2 V min. 750 mAh
batteries. Use only rechargeable batteries but do not mix different brands and types.
8.5 BATTERY REPLACEMENT FOR INFRARED
REMOTE CONTROL
When the infrared remote control does not send out the
transmission signal (led on), the battery must be replaced. Use
a Phillips screwdriver of proper size, to separate the half shells
and replace the battery. The dead battery must be disposed of
safely.
8.6 REPLACING THE BUFFER BATTERY OF THE CONTROL PANEL
Inside the control panel there is a buffer battery type CR 1632. When hour and programming are not kept in storage, the battery
must be replaced using the 4 screws in the rear of the control panel. This malfunction must not be considered a defect as it is the
result of normal battery depletion.
To replace the battery, remove the right side panel of the appliance and then also the control panel A, by undoing the three screws
B that fix it to the structure.
The dead battery must be disposed of safely.
Batteria Tampone
CR 1632
LEGENDA
KEY
Batteria Tampone CR1632
Buffer battery CR1632
