Installation guide
Installation guide
Barrel Nº63
Barrel Nº63
BARRELS
BARRELS
STEP ONE
Place the support cradles (A)
on level site. The middle support cradle
will have no dowel. Carefully level for
better stability.
Place the center stave (B)
on wooden dowels embedded
in outer support cradles (A).
Fix the center stave (B)
with screw 4.2 x 70 (N).
STEP THREE
Place 6 sauna body staves (C, C1)
to each side of the center stave (B)
and fix with screws 4.2 x 70 (N).
Body staves (C)
are left and right sided.
Be sure to align the panel
groove on every next body stave.
STEP TWO
Measure support cradles (A) diagonally
from corner to corner.
Measurements “a” and “b” should be
equal to ensure the cradles are square.
Be sure cradles remain level.
STEP FOUR
Place front panel with sauna doors
(D) and rear panel (D1) into the
trimmed grooves. Be sure each panel
is centered, leveled, and completely
seated into the floor panel.
Bind these panels together by
temporarily placing one or two
body stave (C) on top of them.
STEP FIVE
Two front side panels (E, F)
attach to the front panel (D) and two
back side panels (E1, F1)
attach to the rear panel (D1)
by 4 screws 5.0 x 120 (M) and
4 stainless steel screws 4.20 x 70 (N1).
Be sure the bench supports face the
interior of the sauna.
Confirm that the combined width
of the rear wall (E1, D1, F1)
matches the combined width of
the front wall (E, D, F).
A
B
A=B
N
A
B
Centered
Back
Front
C
M
M
E
M
M
M
M
M
E1
N1
F1
F
N1
N1
N1
B
C1
N
x6 pcs
x6 pcs
C
D
D1
M
