Grill2GO • 17
Note
: When lighting the grill, a small flash of gas may be seen at
the end of the Flash Tube. This is normal and no cause for concern.
Burner Flame Check
• Light burner, rotate knobs from HIGH to LOW. Looking through viewing glass, you
should see a smaller flame in LOW position than seen on HIGH. Always check
flame prior to each use.
Before Your First Cookout.
• Light burners, check to make sure they
are lit, close the lid and warm up grill on
HIGH for 10 minutes. Curing of paint and
parts will produce an odor only on first lighting
Turning Grill Off
• Turn knob to OFF position. Make sure Regulator/Valve pops up. If it does not,
discontinue use and order new part.
• Disconnect 1lb cylinder or turn off valve on 20lb cylinder.
MATCH LIGHTING FOR THIS GRILL
1. Push Regulator/Valve in and turn counterclockwise to LIGHTING POSITION.
2. Wait 3 seconds and place lit match at the mouth of the
FLASH TUBE on front of grill.
Flash
Tube
Viewing
Glass
HIGH
LOW
Heat Indicator Instructions
Indication of warming up
or cooling down.
Cooking Zone.
Too hot, will damage
non-Stick surface.
• If burner does not light
within 5 seconds turn knob
to OFF, wait 5 minutes, try
again.
WARNING
WARNING
WARNING
WARNING
WARNING