26
Changing/Cleaning Filters
We strongly recommend that you clean the filter every one to three weeks depending on how
often your spa is used. Just because a filter is dirty does not mean it needs to be replaced. Fil-
ters that are cleaned regularly can last up to 12 months.
To determine whether your filter needs
replacing look within the pleats of the filter inspecting for any build up of grime and dirt particles
after cleaning. If dirt particles remain the filter should be replaced. Filters are not designed to last
more than 12 months. We recommend using ThermoSpas Filter Clean to clean the filter(s) in
your spa.
Note:
Some ThermoSpas spas use two or more filters.
DANGER:
RISK OF SEVERE INJURY OR DROWNING BY ENTRAPMENT!
• Keep hair, loose articles of clothing or hanging jewelry away from suction fittings, rotating jets
or other moving components to avoid entrapment that could lead to drowning or severe injury.
• Never use the spa unless all suction guards, filter, filter lid, or skimmer assembly are installed
to prevent body and/or hair entrapment.
• Never operate or use the spa if the filter, filter lid, or skimmer assembly are broken or any part
of the skimmer assembly is missing. Please contact your dealer or nearest service center for
service.
• The suction fittings and suction covers in this spa are sized to match the specific water flow
created by the pump(s). If it is necessary to replace the suction fittings, suction covers or
pump(s), be sure that the flow rates are compatible and are in compliance with the VGB
Safety Act.
• Never replace a suction fitting or suction cover with one rated less than the flow rate marked
on the original suction fitting. Using improper suction fittings or suction covers can create a
body or hair suction entrapment hazard that may lead to drowning or severe injury.
• Owners must alert all spa users to the potential risk of Hair, Limb, Body, Evisceration
(disembowelment) and Mechanical Entrapment.
Cleaning The Filter
DANGER: TURN POWER TO SPA OFF! TO DECREASE RISK OF DEATH,
DROWNING, OR ENTRAPMENT, NEVER OPERATE SPA WHEN FILTER IS NOT
PROPERLY INSTALLED OR IF SKIMMER ASSEMBLY IS DAMAGED OR AL-
TERED!
During filtration and automatic cycles, water flows through the spa skimmer and into the filter
cartridge(s) to trap suspended particles and oils on their surface pleats. To ensure optimum
performance, it is necessary to remove and clean the filter cartridge(s) once a month or sooner
depending on spa use and water quality.
The skimmer/filter the Genesis Series can vary. To follow are the two distinct skimmer housing
and the cleaning procedure for each.
Cleaning products for your spa can be purchase at ThermoSpas’ online store at
http://online.ThermoSpas.com.
!
Changing/Cleaning Filters
Summary of Contents for Atlantis Genesis 200
