3
Setting up your ThermaData WiFi Logger
STEP 2
Pairing a device to ThermaData Studio
• From the ThermaData WiFi tab, click ‘My Instruments’ and input the logger’s serial number in the bottom right-hand corner.
(This can be found on the rear label of the logger and reads as ‘D12345678.’)
• If selecting ‘read-only,’ the user will have limited access to the
device and can only view information, while not adjusting device
settings.
• Select ‘read-only’ and enter the 8-digit Connection Key on the
rear of the unit (2nd row) as shown below.
OPTION 1 - READ ONLY ACCESS
• If selecting ‘Full access,’ the user will have unlimited access to
the device and can adjust settings and user access.
• Select ‘Full access’ and you will be prompted to press the
‘Start’ button on the ThermaData WiFi logger’s front panel 5
consecutive times. This will give you a unique and temporary
pairing code for that particular device. Enter this code into the text
bar on the window.
OPTION 2 - FULL ACCESS
(This can be done on any internet connected PC running ThermaData Studio.)
