83
Displaying Mode Change Messages
As discussed in the
MODE
section of this manual, when the Casablanca IV receives a Dolby Digital or DTS
signal on the currently selected input and the
MODE
is different from the incoming signal, a message will briefly
appear on the VFD stating that the Casablanca IV has received a certain format and is temporarily changing
the
MODE
. This message is turned off by default but can be turned on. Pressing button #
2
and changing the
value to
ON
achieves this.
Note
: If the default
MODE
is
DOLBY DIGITAL
or
DTS
and a 96K signal is received, the Casablanca IV will
momentarily display a message (if the
MSG
parameter is set to
ON
) indicating that it is receiving a 96K signal
and [temporarily] changing the mode to
STEREO
. The user can then change this mode by using the front
panel
MODE
button and selecting a different and applicable
MODE
.
Display Time
The Casablanca IV’s display brightness will automatically dim to ¼ if no button has been pressed for
X
minutes.
The value set in the
DTIM
(Display Time) parameter under button #
4
of the
SETUP/GLOBAL
page 2
menu.
Serial Number
Press button #
5
to display the serial number of this Casablanca IV.
Six Shooter
The Six Shooter is an external device that allows the 6 analog output channels of an SACD or DVDA player to
integrate with the Casablanca IV. There are 3 inputs and one output on the Six Shooter. The first two inputs
are designed to receive SACD or DVDA signals. The third input receives the first 6 output channels of the
Casablanca IV. The outputs of the Six Shooter are connected to the amplifier inputs.
The first two-channels of the Six Shooter contain volume controls. The volume for these two inputs is controlled
by the Casablanca IV.
When the Six shooter is used, the user first selects the appropriate
INPUT SELECT
button on the Casablanca
IV, then press
SETUP\INP\A-D\A-D\6SHOT
. Using the
LEVEL UP\DOWN
buttons, select which Six Shooter
input will be used. For all other
INPUT SELECT
buttons on the Casablanca IV, set this parameter to
3
so that
the incoming signal is routed from the first 6 outputs of the Casablanca IV into Input #
3
of the Six Shooter
(which is a bypass) and then directed to the amplifiers.
Please refer to Appendix B for a Six Shooter wiring diagram.
* * *
Summary of Contents for Casablanca IV
