Installation Manual 7
Put the refrigerator in position (see Art02541):
Make sure the combustion seal [28] is not broken, is completely
around the refrigerator mounting flanges [156], and is between
the mounting flanges and the wall of the enclosure. If the
combustion seal is not complete, exhaust fumes can be
present in the living area of the vehicle. The breathing of
exhaust fumes can cause dizziness, nausea, or in extreme
cases, death.
- Remove the door from the refrigerator (See “Reverse the door swing” section).
- Put screws through the holes of the refrigerator mounting flanges and into the
enclosure wall.
To avoid bending the breaker, make sure that the screws are
perpendicular to the breaker and do not overtighten the screws.
- Attach the door to the refrigerator.
- Put a screw through the holes [121] in the braces at the lower rear corners of the
refrigerator and into the floor.
Install the Refrigerator
Installation Options
Install the decorative door panel:
The decorative panels must be 5 mm or less in thickness.
- Make a decorative door panel [38] that is (See Art00977):
- 659 mm high x 511 mm wide for N304M models.
- 787 mm high x 541 mm wide for N404M models.
- 939 mm high x 541 mm wide for N504M
models.
- Push the decorative door panel into the slots [157] of the door end caps
[158].
- Push each panel retainer [37] into the slot on the edge of the door.7
Reverse the door swing:
This refrigerator has hinges that allow you to change the direction that the door opens by moving the hinges to the opposite corner
(See Art02534).
1. Remove the door:
- Turn out and save the upper hinge pin [63].
- Open the door a small amount and pull the top of the door away from the upper hinge of the refrigerator.
- Lift the door off of the lower hinge pin [64].
- Turn out and save the lower hinge pin.
Art00977
38
158
37
157
WARNING
!
NOTICE
NOTICE
28
156
121
ART 02541
