Operation/installation/service manual
MACERATOR TOILETS
Manuale di utilizzo / installazione / manutenzione
TOILET MACERATRICI
X-light / Privilege/ Evolution/ Breeze/ E-Breeze/ Silence Plus 2G/ Elegance 2G
49
TECMA SRL – Via Flaminia / Loc Castel delle Formiche/ 05030 Otricoli (TR) / Italy-
rev 1.2017
1111111111111111
111111111111111111111
1. Some
water
remains in
the bowl
(same as a
residential
toilet)
3. Press the
AFTER USE
button after
using the toilet.
The combined action of the solenoid
valve and macerator pump cleans and
rinses the bowl, leaving a small amount
of clean water ready for the next use
2. Using the
toilet
4. Some water
remains in the bowl
ready for the next
use
4. Some water
remains in the
bowl ready for
the next use
Change flushing mode
–
from sailing mode to mooring mode (Fig.1)
The system is set on sailing mode by default. To switch from sailing mode to mooring mode
1)
Press and hold the BEFORE USE and AFTER USE buttons simultaneously for approximately
3 seconds. The lock LED will flash, indicating that the programming mode is enabled.
2)
Keep pressing and holding both buttons for at least 4 seconds after the lock LED starts
flashing
3)
Release both buttons when the desired water level has been reached
4)
This way, the amount of water to be used the next time is set and the system is set in
mooring mode
5)
Refer to the next paragraph to return to sailing mode
MOORING MODE: water remains in the toilet,
ready for the next use.
