8
2-3 Installation :
Where to install.
The power inverter should be installed in a location that meets the following requirements.
2-3-1 Dry – Do not allow water to drip or splash on the inverter.
2-3-2 Cool – Ambient air temperature should be between -20
and 50
, the cooler the
better.
2-3-3 Safe – Do not install in a battery compartment or other areas where flammable
fumes may exist, such as fuel storage areas or engine compartments.
2-3-4 Ventilated – Allow at least one inch of clearance around the inverter for air flow.
Ensure the ventilation openings on the rear and bottom of the unit are not obstructed.
2-3-5 Dust-free – Do not install the Inverter in a dusty environments where are dust, wood
particles or other filings/shavings. The dust can be pulled into the unit when the cooling fan
is operating.
2-3-6 Close to batteries – Avoid excessive cable lengths but do not install the Inverter in the
same compartment as batteries.
Use the recommended wire lengths and sizes (see section 2-6).
Also do not mount the Inverter where it will be exposed to the gases produced by the
battery. These gases are very corrosive and prolonged exposure will damage the Inverter.
2-3-7 You can choose
Inverter
mode or
UPS
mode freely. If inverter mode fail, the device
will connect to UPS mode automatically. If UPS mode fail, the device will connect to Inverter
mode automatically. It will not influence the performance of server and could supply a
uninterrupted power to the ultimate load.
2-4 Quick hook – up and testing:
2-4-1 Unpack and inspect the power inverter, check to see that the power switch in the OFF
position.
2-4-2 Connect the cables to the power input terminals on the rear panel of power inverter.
The red terminal is positive ( + ) and black terminal is negative ( - ).
Insert the cables into the terminals and tighten relative nut to clamp the wires securely.
WARNING !
You may observe a spark when you make this connection since current
may flow to charge capacitors in the power inverter.
Do not make this connection in the presence of flammable fumes,
explosion or fire may result.
YOUR CONNECTION TO SAFETY
Thiele KG
• V
orderer W
einberg 26 • D-71522 Backnang • T
el.: +49 (0)7191 3560-0
• Fax.: +49 (0)7191 3560-19
• info@thiele-kg.de
• www
.thiele-kg.de
Thiele KG
• V
orderer W
einberg 26 • D-71522 Backnang • T
el.: +49 (0)7191 3560-0
• Fax.: +49 (0)7191 3560-19
• info@thiele-kg.de
• www
.thiele-kg.de
YOUR CONNECTION TO SAFETY
klick to
www
u-s-v
YOUR CONNECTION TO SAFETY
klick to
www
ACDC-DCDC
YOUR CONNECTION TO SAFETY
klick to
www
SYSTEME
YOUR CONNECTION TO SAFETY
klick to
www
CONTACT
YOUR CONNECTION TO SAFETY
klick to
www
CALLBACK