© Adolf Thies GmbH & Co. KG · Hauptstraße 76 · 37083 Göttingen · Germany
021821/08/21
Tel. +49 551 79001-0 · Fax +49 551 79001-65 · info@thiesclima.com ·
Page 68 of 102
7.2.21 Command LL
<id>LL<parameter><CR>
Logger status
Access:
Reading / writing
Description:
With the command “LL”, the current logger status is read out.
Parameter description:
1
Output of the device descriptors re. serial
sensors
2
Output of binary configuration
3
Output of MEVIS compatible configuration
10
Output of the number of data bytes in the input FIFO for
the communication with the LINUX board
11
Output of data bytes in the input FIFO for the
communication with the LINUX board
12
Output of the data bytes in the input FIFO for the
communication with the LINUX board (non-
representable characters with #xx)
20
Output of the ASCII table for LCD (ASCII value, height
and width)
Value range:
Initial value:
0
7.2.22 Command mm
<id>mm<parameter><CR> Output of the instantaneous values
Access:
Reading / writing
Description:
With the command mm, all configured instantaneous values are
output in one line.
Parameter description:
1
Instantaneous values in accordance with archive AV1
2
Instantaneous values in accordance with archive AV2
…
16
Instantaneous values in accordance with archive AV16
Value range:
1…16
Initial value:
