Reader RF Power
M6 and Astra-EX User Guide
68
Setting the Reader RF Power
To set the Reader RF power:
1.
Log on to the Reader using your browser.
The M6 and Astra-EX
2.
Click on the Settings tab.
The first field on the Settings page is RF Power. Its factory default value is 30
dBm.
3.
Enter the maximum setting based on your cable type, length, and antenna type.
4.
Scroll down to the bottom of the
changes button.
The Settings Page will reload automatically after the settings have been saved.
Note
If the Status page does not appear after a minute, manually recycle the power on
the Reader. After repowering, load the Settings Page again and check the new
maximum RF power setting.
Summary of Contents for Astra-EX
