Installation and
maintenance
Installation is done in accordance with the instructions in this document.
Incorrect installation may cause damage to the logger and inaccurate
measurements. That is why the installation, the initial configuration must be
done with due attention.
Incorrect installation results in violation of warranty conditions and failure of the
warranty.
An example of improper installation is to connect the pulse or analog input of
the device shortly or to a power source
Transport and
storage
Store in dry rooms without access to water or other liquids at temperatures not
lower than -20 ° C and not higher than 60 ° C in the original package.
Transportation is allowed to happen accidentally at temperatures below -20 ° C
but not more than 8 hours. Protect against shocks and avoid extreme
conditions.
Subsequent
maintenance
Once installed, the data logger should be cleaned using a dry or lightly
moistened cloth, explicitly prohibiting the use of aggressive and abrasive
detergents.
Every six months, it is desirable for the user of the logger to check the enclosure
integrity and the integrity and waterproofness of the cable and connecting
terminals to the measured device or sensor.
Recycling
When recycling the product and its disposal, local and national legislation and
regulations must be observed. If you hesitate, please return the appliance, we
will recycle it for you.
Table II Health and safety instructions
Visit us at
www.thingslog.com
