4. Driving and Safety
4-20
Children and Safety
Child Seat Installation Using the LATCH (Lower Anchors
and Tethers for CHildren) System
! WARNING
Attach the LATCH system compatible child restraints only at
the front passenger position. Always inspect the lower anchors
by inserting your fingers into the lower anchor area, making
sure there are no obstructions over the anchors. Failure to
follow the warnings and instructions for proper use and
installation of child restraints could result in serious injury
or death of a child or other passengers in a sudden stop or
collision.
This vehicle is equipped with a universal child restraint anchor
system, referred to as the LATCH (Lower Anchors and Tethers
for CHildren) system in the front passenger seat. This system
may also be referred to as the ISOFIX or ISOFIX-compatible
system. With this system, you do not have to use a vehicle seat
belt to secure the child restraint. Some child restraints include
rigid or webbing-mounted attachments that can be connected
to these anchors. If you do not have a LATCH-compatible child
restraint, the vehicle seat belts must be used to secure the child
seat.
The LATCH lower anchors are located
at the rear of the seat cushion near the
seat back. LATCH compatible child
restraints include two rigid or webbing-
mounted attachments that can be
connected to the two lower anchors located at front passenger
positions in your vehicle.
Follow these steps to install a forward-facing child restraint
using the LATCH system:
1. Move the seat to the rearmost position.
2. Position the child restraint on the seat. The back of the child
restraint should be secured against the vehicle seat back.
3. Secure the child restraint anchor attachments to the
LATCH lower anchors. Check to make sure the LATCH
attachment is properly attached to the lower anchors. For
child restraints that are equipped with webbing-mounted
attachments, remove any additional slack from the anchor
attachments.
4. If the child restraint is equipped with a top tether strap,
route the top tether strap and secure the tether strap to
the tether anchor point. The tether anchor point can be
found on the floor of the cargo compartment behind the
front passenger seat. Adjust the head restraints if needed.
Tighten the tether strap according to the manufacturer’s
instructions to remove any slack.
5. After attaching the child restraint, test it before you place
the child in it. If the restraint is not secure, tighten the
LATCH attachment as necessary.
6. Check to make sure the child restraint is properly secured
prior to each use. If the child restraint is loose, repeat steps
above to ensure it is secured properly.
Summary of Contents for think city
