4. Driving and Safety
4-21
Child Seat Installation Using the Safety Belts
! WARNING
The automatic locking retractor (ALR) in the front passenger
seat must be used when installing a child restraint using the
safety belt system. Failure to use the ALR mode will result in
the child restraint not being properly secured and cause injury
to a child in a sudden stop or collision.
Follow these steps to install a forward-
facing child restraint using the safety
belt system:
1. Move the seat to the rearmost
position.
2. Position the child restraint on the
seat. The back of the child restraint
should be secured against the
vehicle seat back.
3. Route the safety belt tongue through the child restraint and
insert it into the buckle until you hear and feel the latch
engage. Be sure to follow the child restraint manufacturer’s
instructions for belt routing.
4. If the child restraint is equipped with a top tether strap,
route the top tether strap and secure the tether strap to
the tether anchor point. The tether anchor point can be
found on the floor of the cargo compartment behind the
front passenger seat. Adjust the head restraints if needed.
Tighten the tether strap according to the manufacturer’s
instructions to remove any slack.
Children and Safety
5. Pull the shoulder belt until the belt is fully extended. At this
time, the seat belt retractor is in the ALR mode. It reverts to
normal sensitive mode when the seat belt is fully retracted.
See page 4-15 for more information.
6. Allow the safety belt to retract. Pull up on the shoulder belt
to remove any slack in the belt. Remove any additional
slack from the seat belt; press downward and rearward
firmly in the center of the child restraint with your knee
to compress the vehicle seat cushion and seat back while
pulling up on the safety belt.
7. Tighten the tether strap according to the manufacturer’s
instructions to remove any slack.
8. Check to make sure the child restraint is properly secured
prior to each use. If the child restraint is loose, repeat steps
above to ensure it is secured properly.
Installing Booster Seats
! WARNING
• Make sure the shoulder portion of the belt is away from the
child’s face and neck and the lap portion of the belt does not
cross the stomach. Never place, or allow a child to place, the
shoulder belt under a child’s arm or behind the back because
it reduces the protection for the upper part of the body and
may increase the risk of injury or death in a collision.
• Choose only a child restraint or booster seat with a label
certifying that it complies with Federal Motor Vehicle Safety
Standard 213. Ensure that the child restraint or booster seat is
compatible with the vehicle’s seat and safety belt system.
Summary of Contents for think city
