4. Driving and Safety
4-30
Tire Pressure Monitoring System (TPMS)
To set your TPMS:
1. Make sure that you have the correct pressure in all 4 tires.
The front tires should be inflated to 36 psi (2.5 bar) and rear
tires inflated to 43 psi (3.0 bar). Tire pressure should always
be checked on cold tires and with an accurate pressure gage.
Performing a TPMS Set sequence with incorrect tire pressures
may prevent the TPMS from functioning correctly and not
indicating low tire pressure or system malfunction.
2. Turn the ignition on and make sure that the vehicle is in “Run
mode” by checking that the green vehicle telltale lamp on the
center stack is illuminated.
3. Press the TPMS Set button for between 3 to 6 seconds, until
the TPMS telltale lamp starts flashing rapidly and a beep noise
is heard. If the vehicle is turned off before this sequence is
complete, the system will indicate a malfunction when the
vehicle is started up again and the TPMS telltale lamp will
flash for about 1 minute and then remain illuminated. If this
happens, start over from Step 2.
4. Drive the vehicle for up to 10 minutes above 15 mph (25 km/h)
until the TPMS telltale lamp stops flashing and a beep noise is
heard from the vehicle. If the speed is reduced below 15 mph
(25 km/h), the learn process will pause. The process will
resume when the speed is above 15 mph again. Increasing the
speed above 15 mph has no effect on the time the TPMS set
process will take.
5. When the TPMS telltale lamp has stopped flashing, the learn
process is complete and the system is fully operational.
TPMS set (under the
plastic panel)
Summary of Contents for think city
