5. Service and Maintenance
5-14
Changing Light Bulbs in Front
Changing the Main Head Lamps Bulb (Halogen)
Changing Turn Signal Bulb
1. Unscrew the cover for the
head lamp.
3. Turn the bulb holder slightly counter-
clockwise and pull out the complete bulb
holder. Take out the main bulb from the
holder and insert the new one. Remember
not to touch the new halogen bulb, use
gloves or a clean cloth.
1. To loosen the turn signal holder, turn
counterclockwise and take out the
holder and bulb.
2. Disconnect the electrical
connector from the bulb.
4. Make sure the guide pins are fed into the
holder correctly. Replace the bulb holder in
the head lamp in reverse order. Remember
to screw the cover back on. Note that the
wires to the lamp are on the inside of the
rubber gasket.
2. Twist the bulb counterclockwise while
pushing in slightly and pull straight out;
replace the bulb and install in reverse
order.
Summary of Contents for think city
