®
T-4200 Chassis, Rev. A
8
September 2011
1.3.5 Display Rocker Switch
The
Display
rocker switch located on the front of the chassis selects which module information is shown
on the LCD. Switched to the right or left, it will show the information for the module located on that side
of the chassis. If there is only one module installed, it will display th
at module‟s information in either
rocker switch position.
1.3.6 Front Panel Display and Buttons
Note: When you receive your T-4200 Chassis, there will be a removable decal that identifies
each module of your specific configuration located on the front panel display.
The front-panel LCD display should be visible and accessible for system setup. The front panel buttons
are used to configure special video settings and to review existing VelocityKVM Extender configurations.
See
Paragraph 3, Front Panel Usage
below, for more information on using the buttons and LCD.
enter
POWER
POWER
Velocity
kvm
T- 4200
Four Single-Link DVI Displays
DISPLAY
MODULE 2
MODULE 1
Power Supply Switches Display Rocker Switch LCD System Information & Programming LCD Navigation
The T-4200 Front Panel
2. Firmware Upgrades
Firmware upgrades are available through Thinklogical. Please call us for technical assistance at:
1-203-647-8700
.
To update the Chassis firmware, use the
KM download
described below. To update a module‟s FPGA,
go to
Allow FPGA Update
under the
*System
menu. Select
Yes
and load the update through the back
panel USB port using the
FPGA Update
, also described below.
Transmitter Upgrade: USB Cable from CPU to CTRL Port
KVM Download Procedure:
Firmware files and revision numbers are stored in the following:
http://ftp.thinklogical.com/ftp/visualization/updates/Firmware.zip
