Chapter 6. Replacing devices
This chapter contains the following items:
•
“Static electricity prevention” on page 75
•
“Disabling the built-in battery” on page 75
•
“Installing or replacing the micro SIM card” on page 76
•
“Replacing the base cover” on page 77
•
“Replacing the solid-state drive” on page 78
•
“Replacing the wireless LAN card” on page 80
•
“Installing or replacing the wireless WAN card” on page 83
Static electricity prevention
Static electricity, although harmless to you, can seriously damage computer components and options.
Improper handling of static-sensitive parts can cause damage to the part. When you unpack an option or
a CRU, do not open the static-protective package that contains the part until the instructions direct you
to install the part.
When you handle options or CRUs, or perform any work inside the computer, take the following precautions
to avoid static-electricity damage:
• Limit your movement. Movement can cause static electricity to build up around you.
• Always handle components carefully. Handle adapters, memory modules, and other circuit boards by the
edges. Never touch exposed circuitry.
• Prevent others from touching components.
• When you install a static-sensitive option or CRU, touch the static-protective package that contains the
part to a metal expansion-slot cover or other unpainted metal surface on the computer for at least two
seconds. This reduces static electricity in the package and your body.
• When possible, remove the static-sensitive part from the static-protective package and install the part
without setting it down. When this is not possible, place the static-protective package on a smooth,
level surface and place the part on the package.
• Do not place the part on the computer cover or other metal surface.
Disabling the built-in battery
You need to disable the built-in battery in the following situations:
• Your computer will be turned off for an extended period of time.
• The micro SIM card needs to be replaced.
To disable the built-in battery, do the following:
1. Disconnect the ac power adapter and all cables from the computer.
2. Restart the computer. When the ThinkPad logo is displayed, press F1 to start the ThinkPad Setup
program.
3. Go to
Config
➙
Power
➙
Disable Built-in Battery
.
4. Press Enter. A Setup Confirmation window is displayed.
© Copyright Lenovo 2014
75
Summary of Contents for X1 Carbon
