Thinkware BAB-95, All-In-One Quick Start Manual

4

FCC

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1)  This device may not cause harmful interference, and
(2)  This device must accept any interference received, including interference that may cause undesired 

operation.

FCC Compliance Statement

Note : This equipment has been tested and found to comply with the limits for a Class A digital device, 
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that interference will not occur 
in a particular installation. If this equipment does cause harmful interference to radio or television 
reception, which can be determined by turning the equipment off and on, the user is encouraged to try 
to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

-   This appliance and its antenna must not be co-located or operation in conjunction with any other antenna 

or transmitter.

-  A minimum separation distance of 20 cm must be maintained between the antenna and the person for 

this appliance to satisfy the RF exposure requirements.

Caution

 :  Any changes or modifications to the equipment not expressly approved by the party responsi-

ble for compliance may void your permission to operate the equipment.

Note

 :  This unit was tested with shielded cables on the peripheral devices. 

Shielded cables must be used with the unit to insure compliance.

This Class A digital apparatus complies with Canadian ICES-003