Reload the staples or nails to the magazine.
Do not use the tool if the safety nose/contact pin cannot move freely.
Place the contact pin on the workpiece and press the machine without pulling the trigger, the machine
should not fire ; Take the machine from the workpiece, the contact pin should spring back
automatically. Pull the trigger, The machine should not fire.
Inserting Staples or Nails into the magazine
NOTE: The number of staples or nails left in the magazine can be read using the viewing window.
a) Remove battery pack from the tool.
b) Press the release button and pull out the magazine cover.
c) Tilt the tool and place nails/staples into the track of the magazine channel.
Make sure that the fasteners are placed correctly:
• Staples are placed against the profiled side of the rail, the crown of the staple is in the uppermost
part of the magazine(legs are facing away from the body of the tool).
• Nails are placed against the profiled side of the rail, with the points of the nails facing downwards.
d) Close the magazine cover until it engages with the release button.
e) Reattach battery pack to tool.
Warning: Do not place fasteners of different length. Do not place staples and nails mixed together.
A.Loading staples: B. Loading nails:
Instructions for use
Prior to operation make sure your battery pack is fully charged.
Check whether the fasteners are placed in the magazine correctly.
Nailing or Stapling
Hold handle firmly with magazine flat to work piece forming a 90° Angle.
Two modes of firing: Single Firing and Contact Firing
1) Single Firing Mode:
Push the drive shift (single/contact firing knob) to left side, it is on Single Firing mode . Single Firing is
good for precision placement .
Step 1: Push the drive shift to left side
04
