If the fasteners remain jammed after following the above instructions, slightly loosen the hex screws
upon the nosepiece with the wrench provided then remove the jammed fasteners pieces
(
see
bellowing photo, just loose these two screws , not loose other screws, don’t remove the whole nozzle
cover
)
Remove the jammed nail with pliers if necessary. After the jammed nail has been successfully
removed , then re-tighten the nose piece with hex screws securely.
Reload on the staples/nails, close the magazine, then insert on the battery to shot . If still not shot,
open the magazine, remove staples/nails, keep opening the magazine to shot one or two times , then
load on staples/nails ,close the magazine to shot , will be ok .
Do not dispose of power tools into household waste !
Recycle unwanted materials instead of disposing them as waste.
Battery packs/ batteries Recycling: Li-ion Battery.
The battery packs are built to the highest quality standards, they can be re-charged again and again,
ensuring that your tool performs with full efficiency. However, rechargeable batteries eventually need
to be replaced. When this happens, it is important not to discard your old battery tool or battery pack
in a hazardous manner. To preserve natural resources, please recycle or dispose of batteries
properly.
These battery packs should be collected, recycled or disposed of in an environmental-friendly
manner.
Warning: Do not attempt to destroy or disassemble battery pack or remove any of its components.
Also, never touch the battery terminals with metal objects and/or body parts as short circuit may
result. Keep away from children.
Contact us
Should you have any questions about the item,or any thinkwork tool ever fails to give complete
satisfaction,save time and contact us for replacement,and our email is:
support@thinkworktools.com
We are open Monday through Friday from 8:00 a.m. to 5:30 p.m. Eastern Standard-Time.
07